Knowledgebase: Powder Handling
Excessive Leaking Auto Disk Powder Measure Fine Ball Powders
Posted by Steph @ Lee Precision on 14 February 2012 02:03 PM

If you are using fine ball powders and have excessive leaking with your Auto Disk Powder Measure, you are able to sand down the two risers on the body to nearly eliminate leakage.

1) Remove the disks and hopper

2) Place a disk between the risers, with a piecce of scotch tape on top, and use a file or sandpaper attached to a flat surface, and file/sand until contact is made with the scotch tape.

Submit Help Ticket or Ask a Question
Help Desk Software by Kayako case