RSS Feed
Knowledgebase : Product Support > Case preparation > Quick Trim
The Lee 280 Ackley Improved die set we offer should not be used to size cases for rifles chambered for the SAAMI 280 Ackley Improved. The Full Length Sizing Die has a .014" longer head space than the SAAMI 280 Ackley Improved specification. Cases siz...
As long as the Trim Length and the case head to shoulder intersection length is the same between your Ackley Improved brass and the standard parent cartridge, you will be able to use the parent cartridge Quick Trim Die for your Ackley Improved cases....
The case trimming dies will work fine in the Breech Lock Bushing and Lock-Ring Eliminator bushing. As long as the end of the collet / die contacts the shell holder, the case will be trimmed properly.
WITH THE ADDITION OF INEXPENSIVE CARTRIDGE SPECIFIC QUICK TRIM DIE BODY, YOU WILL BE ABLE TO QUICKLY AND PRECISELY TRIM YOUR BRASS TO THE CORRECT LENGTH WITH PRESS-MOUNTED CONVENIENCE. The Deluxe Quick Trim Case Trimmer quickly and precisely trims y...
For a Quick Trim Die to be interchangeable with another caliber, the base diameter, trim length and the case head to shoulder intersection length must be the same. If looking at the attached worksheet, measurements A, B and D must be the same. If the...
Periodically clearing the chamfer blades of metal chips needs to be done to prevent the blades from sticking. This can be done by pushing the trimmer down onto a flat hard surface two or three times to make the chamfer blades retract fully into the b...
HOW TO REPLACE DELUXE CUTTER BLADE AND PIN ON QUICK TRIM Pin for body service part: https://leeprecision.com/molded-parts-qt.html [https://leeprecision.com/molded-parts-qt.html] Video on how to replace pin inside cutter body of Quick Trim:  https:...
If you have a die that uses o-rings at the base. Here is a list of o-rings that your die used. RIFLE CARTRIDGE  O-RING   RIFLE CARTRIDGE O-RING 17 REM  AS-012 PART # AP1703 [HTTPS://LEEPRECISION.COM/3-8X1-2-O-RING.HTML]   ...
We produce a Quick Trim solution for trimming the 204 Ruger that mounts on top of your reloading press. Simply install the appropriate quick trim die in your press and start trimming. Please see the following link for more information: http://leep...
As a general rule when you are trimming cases using the Lee Quick Trim Dies the knurled metal Spacer must be removed from the trimmer for cases with a maximum trim length shorter than 1 1/4" or 1.25". However, there are a few exceptions to this rule....