RSS Feed
Knowledgebase : Product Support > Case preparation > Case Conditioning
Essentially, this tool is a mini-lathe. Using the shell holder that comes with the appropriate case length gauge, a deprimed case is mounted to this unit in the same way they are mounted to the lock stud that comes with the cutter. With three pulls ...
The 3 Jaw Chuck will only work for .625 or smaller rimmed diameter. If larger than this diameter, the rim of the case wil not fit in the 3 Jaw Chuck. WILL NOT WORK ON THE FOLLOWING CALIBERS: * 50/70 * 50/90 Sharpe * 50 Rem * 577 Snyder ...
Currently, we do not offer a system to deprime Berdan cases. These are cases that instead of a single central flash hole at the bottom of the case, there are two small holes on either side of center. This results in the decapper of the sizing die att...
The Chamfer Tool [http://leeprecision.com/chamfer-tool.html] is used after case trimming to deburr and chamfer the inside and outside of case necks. It can also be used to remove the crimp from primer pockets of Military/G.I. Brass. Our Chamfer Tool ...
The chamfer tool (catalog #90109) can be used to remove the crimp from the primer pocket of military cases. It can be power driven with an attachment intended for the Dremel Moto-tool. Look for the sanding drum attachment, which is a small rubber cyl...
The cutters can be sharpened with a sharpening stone. The trick is keeping the 4 blades the same length. If you return the cutter to the factory, we will can replace the cutter for 1/2 the current retail price + shipping. Lee Precision 4275 Highwa...
We do not sell replacement parts individually for the Zip Trim as the internal mechanism needs to be assembled at the factory. Please send in your Zip Trim to us and we will repair it for you at no charge. Our address:  Lee Precision, Inc. 4275 H...